Pipe Fitter Offset Calculator

Cut length after the root gap from ASME takeout tables, and miter, saddle and lateral wrap templates drawn at true scale in a PDF. Rolling offsets with the multiplier shown, so you can check the math: 1.4142 for a 45, not a rounded guess. One price, no subscription, no account, and no signal needed in a plant basement. TAKEOUTS AND CUT LENGTH Pick the fitting at each end and the size, enter centre to centre, and get the cut length with every subtraction listed: both takeouts and one root gap per weld. Butt-weld fittings to ASME B16.9 from NPS 1/2 to 24 (NPS 22 not included), socket-weld fittings to ASME B16.11 Class 3000 from NPS 1/8 to 4 with the engagement gap. Cut 90 elbows down to any angle, with arc marks. Every table names the manufacturer catalogues it was checked against. WRAP TEMPLATES Miter elbows from two to five pieces or a single cut, saddle or fishmouth branches, and laterals from 30 to 89 degrees, with the header hole layout. Export a PDF on A4 or Letter, tiled across sheets with overlap marks. Every sheet carries a 100 mm bar and a 4 inch bar drawn at true size in the PDF: print at 100 percent with no fit to page, measure both bars, then wrap and trace. Includes an ordinate table for marking by hand. OFFSETS THAT SHOW THEIR WORKING Simple offsets at 11.25, 22.5, 30, 45, 60 or any angle. Rolling offsets from set and roll, or solve the angle from a fixed run. Parallel offsets for two to eight lines on a rack. Each answer is a sketch with the arithmetic under it. MILLIMETRES AND INCHES TOGETHER Type 12 5/16, 1' 0 5/16 or 313. Every answer shows both units, to 1/16 or 1/32 inch and 1 or 0.5 mm. PIPE DATA OD, wall, ID, weight, water-filled weight and volume by schedule from 10 to XXS. Flange bolt charts for ASME B16.5 Class 150 and 300: stud count, stud size, bolt circle and stud length. JOBS Save results to a job with a spool label. Export a CSV or a PDF cut sheet, back up everything to one file and restore it. One-time purchase. No ads, no subscription, no account. Works fully offline. Results are reference values for trained fitters. Check against your drawings and fittings before cutting. Not affiliated with ASME.