HoodProof: Hood Cleaning Log

excessive capitalisation._ HoodProof is an offline kitchen exhaust cleaning log for hood cleaning contractors, restaurant facilities managers and multi-site operators. It maps an exhaust system zone by zone, records grease readings under the standard the site is worked to, pairs before and after photographs to each zone, and produces the cleaning report the customer is handed. The core logging and PDF workflow needs no signal and no account. Two standards, two different measurements NFPA 96 and BESA TR19 Grease both look at grease deposits, but the measurement method, the units and the decision rules differ. NFPA reads accumulated grease depth with a grease depth gauge comb. TR19 uses wet film thickness testing, and deposit thickness testing where deposits are hard or carbonised. HoodProof renders one standard's scale at a time, labelled with its instrument, so a reading is never entered against the wrong rule. Each site is set to its own standard, and every visit stamps the standard it was measured under, so switching a site never re-judges a record you have already signed. The figures it works to • NFPA 96: cleaning is required where a measured depth of 0.078 in (2,000 µm) is observed, or 0.125 in (3,175 µm) in a fan housing, and surfaces are cleaned to a maximum of 0.002 in (50 µm). HoodProof judges the fan housing against its own figure rather than the surface one. • TR19 Grease: the mean must not exceed 200 µm between scheduled cleans, a point at 500 µm or above needs local or spot cleaning, and representative post-clean measurements must not exceed 50 µm. Readings are compared against the limits of the standard you selected. Neither standard defines a whole-system pass or fail, so the summary the app shows is its own, of the most severe surface, and it says so. What it does • Six zones per system, from the hood canopy and baffle filters to the upblast fan bowl. Six zones is HoodProof's workflow, not a division either standard prescribes. • Every zone is measured twice: once on arrival, once after cleaning. The post-clean reading is what verifies the clean, and an event with none is recorded as not verified rather than passed. • A measurement dial that shows the active standard's scale only, with the figures that standard sets marked on the face. • Before and after photographs paired to each zone. • An inaccessible section register. Log each section you could not reach, why, and a photograph, with the corrective recommendation. It is reproduced on the report under its own heading, so the record shows exactly what the report covers. • A service checklist covering belt tension, hinge kit, electrical disconnect and lockout, grease drip cup and access panel gaskets. It is HoodProof's checklist, not a complete NFPA 96 inspection. • A cleaning report as a PDF, carrying the zone reading table, the photo pairs, the inaccessible register, your company details and the technician signature. Plus a printable hood service label showing the clean date, the next due date and your company name, address and phone. • Inspection intervals from NFPA 96: monthly for solid fuel, quarterly for high-volume, semi-annually for moderate-volume and annually for low-volume operations. NFPA schedules the inspection and cleaning follows from what it finds, so HoodProof tracks the inspection due date and records the clean separately. Reminders at 30, 14 and 3 days. What it is not HoodProof is a record-keeping and measurement-logging tool. It reduces paperwork and organises cleaning evidence. It does not substitute for a competent inspection, it does not certify anything, and a report it produces covers only the sections actually accessed and recorded. It is not affiliated with NFPA or BESA. Standard tier covers one site with one exhaust system and three cleaning visits, and shows ads. Records you have already made stay readable. Contact [email protected] https://clearstackapps.com/privacy