Bendwise: Conduit Bending Calc

Bend marks in three taps. Bendwise is a conduit bending calculator app built for electricians and apprentices. Enter your offset depth, pick an angle, and get the first mark, the distance between marks, and the shrink, with take-up already figured in. It covers offsets, saddles, kicks and 90 degree bends in EMT, IMC and rigid, from everyday EMT bending on a hand bender to 4" rigid on a hydraulic bender. EVERYDAY BENDS, FREE - Offset bends, with shrink and the offset multiplier shown - 90° stub-ups and back-to-back 90s - Kicks and kick 90s - 3-point and 4-point saddle bends - Angle check: lay your phone on the bent leg and see PASS, OVER or UNDER MATCHED TO YOUR CONDUIT BENDER - 350 benders built in and free to use: hand, mechanical, electric and hydraulic, for EMT, IMC and rigid, 1/2" to 4" - Radius and deduct come from the makers' own manuals and catalogs wherever they are published - Marks follow the centerline radius of your shoe, and one switch takes you back to the conduit bending chart you already know - A warning when a bend cannot be made, before you waste a stick of pipe BUILT FOR THE JOB SITE - Big, high-contrast numbers you can read at arm's length - A light theme for direct sun - Fractions to 1/16", feet and inches, millimeters or centimeters - Type the numbers or slide them with a gloved thumb - Works fully offline. No ads, no account, no data collected BENDWISE PRO (ONE-TIME PURCHASE) - Rolling offsets, parallel offsets and matching offsets - Matching and parallel kicks - Compound 90s around a column or a box, and segmented 90s - Calibrate your own bender: bend one test stub, enter the measurement, and every result after that matches your shoe - Save bends by job, lay several bends out on one conduit, and export a PDF cut sheet Pay once. No subscription. FOR JOURNEYMEN AND APPRENTICES Whether you call it conduit bending or pipe bending, Bendwise is an electrician's calculator that does one job. Journeymen get the marks fast when the run has to go in today. Apprentices see the math on every result (radius or multiplier, shrink, mark spacing), so the numbers start to make sense. Bendwise gives guidance; always confirm against your bender's own marks. Bendwise is an independent app and is not affiliated with any bender manufacturer.