EdgeSlider Pro (V+B control)

EdgeSlider Pro is a powerful yet simple tool that provides an invisible, non-intrusive thin slider along the left and/or right edge of the screen to directly control the volume and/or screen brightness at all times. It is highly responsive and provides precise and quick adjustments by sliding your finger along the edge. No matter which app you are using, adjusting volume and brightness has never been so quick and effortless. It is easy to setup and runs as a background service with minimal use of resources. Experimental PRO feature: Volume booster. Once enabled in the app's preferences, sliding beyond the maximum volume will show buttons for up to 3 volume gain levels. Use with care. This feature does not work with all devices. Try it on yours! EdgeSlider Pro can extend the lifetime of your volume buttons by reducing wear. Great also for devices with broken hardware volume buttons! To start it, just open the app, adjust the options as needed and enable EdgeSlider through the master switch. (The first time you will need to grant some permissions depending on your device.) Once the master switch is on, you may close the app (EdgeSlider will continue to run in the background). There will be an icon in the status bar indicating that the service is active. - Fully customizable volume AND/OR brightness control: control only volume, only brightness or both, left or right side or both at the same time, full or half height with top, bottom or center positioning - Three edge slider sizes: S, M, and L. - Optionally: when changing the volume, the system's graphical volume slider appears shortly, giving you quick access to the other volume channels - Brightness can be set to linear or exponential control - Gesture for quick disabling: Swipe horizontally from the edge to the center of the screen to temporarily (10s) disable the slider on that edge - Quick settings tile. Note: to ensure the QST works properly, and to hinder the system from stopping the app running in the background, we highly recommend to set the battery settings of the app to "Don't optimize" or "Unrestricted". (Long-press on the app icon > App info > Battery.) - User friendly design - Minimal use of resources - Starts automatically at restart if it was active before shutdown Permissions: 1. Display over other apps: Needed in order to appear on top of other apps or homescreen (even though the slider is invisible). You should always be careful with apps that require this permission, since it gives access to the screen content and allows to capture user input. For your peace of mind, this app has no network permissions, so there is no way that any data could be sent out of the app. 2. Modify system settings: This is needed only for controlling the screen brightness. If you plan to use EdgeSlider for volume control only, you may leave this permission disabled. 3. Run at startup: This is needed to automatically re-activate the service if it was active prior to restarting the device. 4. Notifications permission for Android 13 or newer. This is needed in order to display the icon on the status bar. Otherwise, the service will be terminated by the system after a while. Note 1: In some cases and depending on your device, the system's battery optimization might terminate the service and the icon in the status bar will disappear. In this case, we recommend to manually disable the battery optimization for the app (via system settings or app info). Note 2: The icon is necessary in Android 8+ for any service to keep running in the background.