Conduit Bend Calculator - EMT

The conduit bending calculator electricians actually keep in their pocket. Conduit Bend Calc figures out every EMT, Rigid, and IMC conduit bend in seconds — offsets, rolling offsets, 3-point and 4-point saddles, 90° stub-ups, and kicks — with all the mark spacing, multipliers, and deducts done for you. Whether you are bending your first stick of EMT or running a crew, stop digging through charts on a ladder: enter two numbers and get back exactly where to mark your pipe, every single time. • Offsets — enter the offset depth and bend angle, get the spacing between marks instantly, no multiplier chart lookup • Rolling offsets — 3D rolling offsets solved automatically; rise, roll, and run with the cosecant and multiplier math handled for you • 3-point & 4-point saddles — center mark and end marks for any obstruction width, plus parallel saddle spacing for neat racks of pipe • 90° stub-ups — enter the stub height; deduct and take-up calculated automatically so every stub hits its mark • Kicks & segment bends — kick bends, segment bends, and doglegs solved in seconds, with mark order shown • Shrink & gain — built-in shrink table, gain correction, and per-angle deducts so fittings land exactly where you planned • EMT, Rigid & IMC presets — bender-shoe deducts and take-up matched to each conduit type, so your numbers fit your bender • Fractional inch input — fractions, decimals, or feet-inches: enter measurements the way you read them on your tape Built around how electricians actually work. Punch in the numbers you already know — obstruction width, stub height, offset depth — and get back mark positions in plain inches and fractions you can transfer straight to the conduit. Every result shows the multiplier and angle used, so you always know why the number is what it is, not just what it is. It is the conduit bender app you reach for on a ladder, in a panel room, or in the shop. Perfect for: apprentice electricians learning the bender, journeymen who want bends right on the first stick, electrical contractors and crew leads who cannot afford wasted pipe, maintenance technicians bending conduit on the fly, and trade schools teaching conduit bending. If you bend pipe for a living — or you are learning how — this is your pocket reference and your study aid in one. Speaks your trade's language. Every bend you will ever meet on a jobsite: offset bend, rolling offset, 3-point saddle, 4-point saddle, 90 degree stub up, kick bend, segment bend, dogleg, shrink, gain, take-up, deduct, cosecant multiplier, parallel offsets, and stub marks. Works with EMT, Rigid, and IMC conduit, with bender shoe data matched to each type. No manual trig, no guessing the multiplier, no wasted sticks of conduit — just mark, bend, and move on. Download Conduit Bend Calc today — bend it right the first time.